Manual tuning mode: Repeatedly press TUNE to manually move through the frequency bands.ģ X triple USB charging ports This unit includes three USB ports placed inside the Cover (see"location of controls"). Scanning mode: Press and hold to scan through the frequency bands scanning starts from the currently-tuned station and stops when a station is received. Preset tuning mode: Press the PRESET BUTTON repeatedly to select the desired preset (P01 to P10). There are multiple methods to select the station of your choice. Playing the radio Press the POWER BUTTON to switch the unit ON. Location of controls (con’t) Battery Compartment DC Power In Jack Wire Antenna LCD display 1 2 7 PRESET 3 4 1 2 5 8 9 10 FM AM PM 6 DST 11 Low Battery Preset Snooze Alarm 1 Alarm 2 PM AUX In Buzzer FM radio AM DST (Daylight Savings Time) Location of controls 12 11 13 15 Power Button Alarm 1 Button Alarm 2 Button Preset Button LCD Display Snooze Button Volume / Brightness Down Button Volume / Brightness Up Button Tuning Down / Min Button Tuning Up / Hour Button Triple USB Charging Ports 3. Replace the battery door back on the compartment. Alkaline batteries are recommended for the longest playing time. Open the battery door by pushing in on the tabs, then removing the door. ![]() Inserting batteries Two (2) ‘AAA’ size batteries are used to back-up the clock, alarm time and preset memories if the AC/DC adapter is disconnected or there is a power failure. notes: Disconnect both ends of the power cord when not in use. ![]() ![]() The output of the provided AC/DC Adaptor is DC 5V 3A. Connect the other end to a wall outlet providing 100-240V AC, 50/60 Hz. power source ac connection AC outlet Insert the small end of the AC adaptor into the DC In Jack (located on the rear of the unit). Inside the box CR220 Digital FM clock radio, AC power adapter, user guide, a set of cable spool and cable clip. Batteries should not be exposed to excessive heat such as direct sunshine, fire, etc. Please note the information printed underneath the unit. Ensure that the AC/DC adaptor is easily accessible. To ensure that this unit is completely disconnected, unplug it from the wall. Keep liquid-filled objects such as vases, away from this unit and AC/DC adaptor. Do not expose this unit or the AC/DC adaptor to dripping or splashing water. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. DANGEROUS VOLTAGE: The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. Repeatedly press the ALARM 1 or ALARM 2 button to select alarm off, alarm on, for buzzer, radio or CD.Stand & Charge USB Charging Station with Dual Alarm Clock Charge 3 mobile phones, tablets & digital cameras including iPhone, iPod, iPad and Android devices Keeps cables organized CR220 user guideĬAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). Press the ALARM 1 or ALARM 2button again (or wait approx. Press the MINUTE button to set the alarm minute and the HOUR button to set the alarm hour. Press and hold the desired ALARM 1 or ALARM 2button the alarm time will blink. Press the MINUTE button to set the alarm.Ģ. ![]() The Alarm 1 or Alarm 2 time and settings will appear. With the power off, press the desired ALARM, Press and hold the desired ALARM 1 or ALARM 2 button the alarm time will blink. Make sure to set the correct AM/PM setting.ģ Press the TIME button (or wait approx. Press the MINUTE button to set the present minute and the HOUR button to set the present hour. With the power off, press the TIME button the time will blink.Ģ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |